LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1996 >> Chevy Express G2500, Van Cargo Extended, 4L60E/M30 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System & Component Testing - G Series (Diesel) >> Fuel System >> Glow Plug Controller
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Glow Plug Controller

  1. Ensure coolant temperature is less than 80°F (27°C) before beginning test. Place ignition switch in RUN position and allow glow plugs to cycle. After 2 minutes, crank engine for one second. It is NOT important that engine starts. Return ignition switch to RUN position. Glow plugs should cycle on at least once.
  2. If glow plugs do not cycle, disconnect controller (controller is located on top rear of valve cover). Connect test light between Pink/Black wire terminal of harness connector (terminal "A") and ground. See Figure . With ignition switch in RUN position, test light should be off. Test light should illuminate when engine is cranked.
  3. If test light does not illuminate as specified, repair short or open in engine harness Pink/Black wire. If test light illuminates as specified but glow plugs do not cycle, replace controller.
scientia non olet · About LEMON Manuals