Spark Plug Replacement

REMOVAL PROCEDURE
1. Remove the beauty covers.
2. Remove the spark plug wires.
3. Loosen each spark plug one or two turns.
4. Brush or use compressed air to remove any dirt around the spark plugs.
5. Remove the spark plugs one at a time and place each plug in a tray marked with the corresponding cylinder numbers.

INSTALLATION PROCEDURE
1. Inspect each spark plug gap. Adjust each plug as needed.

Specification
Spark plug gap: 1.524 mm (0.060 in).

2. Hand start the spark plugs in the corresponding cylinders.

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Tighten the spark plugs.

Tighten
Tighten the spark plugs to 15 N.m (11 lb ft).

4. Install the spark plug wires.
5. Install the beauty covers.