Main Relay (Computer/Fuel System): Service and Repair

The main relay mounts on a bracket. The bracket is bolted onto the right hand side of the heater case.

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Pull out the panel compartment while pushing the stopper from both the left and right sides.
3. Remove the 2 screws and the relay mounting bracket from the heater case.
4. Release the locking tab in order to remove the main relay from the mounting bracket.
5. Disconnect the main relay electrical connector (5).
6. Remove the main relay from the vehicle.

INSTALLATION PROCEDURE
1. Connect the main relay electrical connector (5).
2. Install the main relay to the mounting bracket.
3. Install the relay mounting bracket to the heater case. Secure the bracket with the 2 screws.
4. Close the panel compartment.
5. Connect the negative battery cable.