LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 1999 >> Astro Van Cargo, RWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft System >> Repair Instructions >> PASSLOCK Reprogramming Seed and Key >> Steps
April 5, 2026: LEMON Manuals is launched! Read the announcement.

PASSLOCK Reprogramming Seed and Key: Steps

IMPORTANT: Erase the passlock™ related diagnostic trouble codes (DTCs) that are stored in the VCM. If there are any powertrain related DTCs, record those DTCs.
IMPORTANT: In addition to the time involved in performing the specific steps, the Seed and Key procedure accomplishes the same task in 10 minutes as the Auto Learn procedure does in 30 minutes. Use either one of these two procedures.

The following is the Seed and Key Learn Procedure:

  1. Insure the ignition key is in the ON position.
  2. Clear all passlock™ module and VCM DTCs, note and refer any VCM DTCs to Powertrain On Board Diagnostic (OBD) System Check in Engine Controls - 4.3L
  3. With scan tool (TECH 2) connected to the vehicle, select "Programming/Request Info" from menu, then follow instructions.
  4. Disconnect scan tool from vehicle and perform "Service Programming System/VTD Learn" with Techline terminal, then follow instructions.
  5. Reconnect scan tool to the vehicle.
  6. Follow instructions on the scan tool to perform the VTD password learn on the vehicle, this takes about 10 minutes.
  7. After 10 minutes, the SECURITY indicator will turn OFF. The new security code is ready to be communicated among the Passlock sensor, Passlock module and VCM. The new Password is learned on the next ignition lock cylinder cycle from OFF-to-CRANK-to-ON (start attempt).
scientia non olet · About LEMON Manuals