Ignition Control Module: Service and Repair

REMOVAL PROCEDURE
1. Disconnect all the electrical connectors at the ignition control module.
2. Note position of spark plug wires for installation and disconnect the spark plug wires from ignition coils.
3. Remove the screws securing coil assemblies to ignition control module.
4. Remove the ignition control module and coil assembly from the module bracket.
5. Disconnect the coils from ignition control module.





INSTALLATION PROCEDURE
1. Reinstall the coils to ignition control module.
2. Position the module/coil assembly on the module bracket

NOTE: Refer to Fastener Notice in General Information.

3. Reinstall the screws.

Tighten
Tighten the screws to 4-5 N.m (40 lb in).

4. Connect the spark plug wires as noted during removal.
5. Connect the electrical connectors to the ignition control module.