Transmitter Programming
NOTE:
To reprogram transmitters with scan tool, refer to scan tool instructions.
- Close driver door. Hold down UNLOCK button on door switch. Turn ignition switch to ON position, then to Off position twice. Release UNLOCK button. Remote Control Door Lock Receiver (RCDLR) should lock, then unlock doors to indicate it is in programming mode.
- Hold down LOCK and UNLOCK buttons on transmitter until RCDLR locks and unlocks doors.
- Repeat step 2 for each transmitter.
- Turn ignition on to exit programming mode.
NOTE:
All transmitters must be programmed at this time. When first transmitter is programmed, all previous transmitters are erased.