LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2000 >> Impala LS >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Monitor System RECALIBRATION >> Using Scan Tool
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Using Scan Tool

  1. Turn ignition switch to OFF position.
  2. Ensure all tire pressures are adjusted to the pressure recommended on tire pressure label.
  3. Connect scan tool. Turn ignition switch to ON position, with engine off.
  4. Using scan tool, select "SPECIAL FUNCTIONS".
  5. Select "TIM RESET". Press RESET soft key.
  6. If necessary, use scan tool to clear any TPM Diagnostic Trouble Codes (DTCs).
  7. After resetting, the TPM system requires up to 30 minutes of straight line driving in each of the following speed ranges to complete calibration process:
    • 15-40 MPH (24-64 KM/H).
    • 40-70 MPH (64-113 KM/H).
    • 70-90 MPH (113-145 KM/H).
    NOTE: The EBCM learns tire pressure calibration for each speed range independently. In Monitor Mode 1, EBCM has only partially learned tire pressure calibration for speed range and has limited detection capability for a tire pressure condition. In Monitor Mode 2, EBCM has fully learned tire pressure calibration for speed range and has full detection capability for a tire pressure condition.
NOTE: Learning process does not need to be completed during a single trip.
scientia non olet · About LEMON Manuals