Specifications Index
ASTRO & SAFARI SPECIFICATIONS INDEX
| System | Specification/Procedure | |
|---|---|---|
| Air Conditioning | ||
| Service | SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Axle Nut/Hub Nut (AWD) | 147 Ft. Lbs. (200 N.m) | |
| Battery | BATTERY TESTING & INSPECTION | |
| Brakes | ||
| Bleeding Sequence | RR, LR, RF, LF also see BLEEDING BRAKE SYSTEM | |
| Disc Brakes | DISC BRAKE SPECIFICATIONS | |
| Drum Brakes | DRUM BRAKE SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Charging | ||
| Generator | GENERATOR SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Drive Belts | ||
| Adjustment | BELT ADJUSTMENT | |
| Belt Routing | See appropriate illustration under SERPENTINE BELT ROUTING & ALIGNMENT | |
| Engine Cooling | ||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | |
| Radiator Cap Pressure | 15 psi (or specification on cap) | |
| Thermostat R&I | NA | |
| Water pump R&I | WATER PUMP REMOVAL | |
| Engine Mechanical | ||
| Compression | Lowest compression reading should not be less than 70 percent of highest compression reading. No cylinder compression reading should be less than 100 psi (7 kg/cm2 ). | |
| Oil Pressure | 6 psi @ 1000 RPM 18 psi @ 2000 RPM 24 psi @ 4000 RPM |
|
| Overhaul | See illustrations under ENGINE MECHANICAL SPECIFICATIONS | |
| Torque | See illustration(s) under FASTENER TIGHTENING SPECIFICATIONS | |
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | |
| Flywheel/Flex Plate Torque | 75 Ft. Lbs. (100 N.m) | |
| Fuel System | ||
| Pressure Specification | 60-66 psi (4.2-4.6 kg/cm2) | |
| Fuel pressure Test Procedure | FUEL SYSTEM PRESSURE TEST | |
| Ignition | ||
| Firing Order & Cylinder Identification | See FIRING ORDER & CYLINDER IDENTIFICATION | |
| Ignition Wires (Resistance) | 30,000 ohms maximum | |
| Ignition Wires (Routing) | For Spark Plug Wire Routing, see 4.3L illustration under FIRING ORDER | |
| Spark Plug | ||
| Type | AC Part No. R41-932 | |
| Gap | .060 in. (1.52 mm) | |
| Torque | 11 Ft. Lbs. (15 N.m) | |
| Starting | ||
| Starter | SYSTEM TESTS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel Alignment | ||
| Adjustment | WHEEL ALIGNMENT SPECIFICATIONS | |
| Torque | TORQUE SPECIFICATIONS | |
| Wheel & Tire | ||
| Wheel Lug Nut Torque | 140 Ft. Lbs. (190 N.m) | |