Accelerator Pedal Position Sensor: Service and Repair
ACCELERATOR PEDAL POSITION (APP) SENSOR REPLACEMENTREMOVAL PROCEDURE
1. Remove the exterior retaining bolt and discard.
2. Remove the left instrument panel insulator (1).
3. Disconnect the harness from the throttle actuator control (TAC) module.
4. Remove the interior retaining bolt and nut.
5. Remove the pedal of the TAC module assembly from the vehicle.
INSTALLATION PROCEDURE
1. Install the pedal of the TAC module assembly to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the interior retaining bolt and nut.
Tighten
Tighten the bolt to 25 N.m (19 lb ft) and tighten the nut to 20 N.m (15 lb ft).
3. Connect the harness to the TAC module.
4. Install the left instrument panel insulator (1).
5. Install the new exterior retaining bolt.
Tighten
Tighten the bolt to 8 N.m (10 lb ft).