Special Functions

This mode performs functional tests on ABS/TCS system which help to verify proper operation. In this mode, testing and observing the test results can further identify malfunction conditions. Under this test, the following tests are available:

• Automated Test
  
  This test cycles each solenoid valve and pump motor to check component operation. This is identical to self-test that is performed when ignition switch is turned to RUN position. A DTC will set if malfunction is detected.
• Automated Bleed
  
  Used to bleed ABS hydraulics.
• Solenoid Test
  
  This test activates selected solenoid valves, commanding solenoid on and off.
• Pump Motor Test
  
  This test turns pump motor on and off.
• Steering Wheel Position Sensor Test
  
  This test monitors the analog and digital steering angle position and can only be run after the Steering Wheel Position Sensor has been centered.