LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2001 >> Tracker 2D Utility, RWD, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Body Control Modules >> Programming >> Transmitter Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transmitter Programming

NOTE: Vehicle can be programmed for up to 4 transmitters. If the number of transmitters programmed exceeds 4, previously programmed transmitters will be erased, starting with first transmitter. All transmitters to be used must be programmed in same programming sequence.
  1. Using a fused jumper wire (5-amp), connect Data Link Connector (DLC) terminals No. 4 (Black wire) and No. 8 (Pink/White wire). See Fig 1 . Door locks will cycle once to indicate entering programming mode.
  2. Within one minute, repeatedly press lock and unlock buttons on transmitter simultaneously until door locks cycle once.
  3. Within 30 seconds, repeat step  2 for each additional transmitter to be programmed.
  4. Disconnect fused jumper wire from DLC, to exit programming mode.
Fig 1: Identifying Data Link Connector Terminals
G00050869Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals