LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2002 >> Camaro Base, 2D Convertible, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Front Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place a new stud in the wheel hub.
    2. Fig 1: Installing Wheel Stud
    GM65317Courtesy of GENERAL MOTORS CORP.
  2. Install some washers onto the wheel stud.
  3. With the flat side of a wheel nut (2) against the washers, tighten the wheel nut until the wheel stud head seats against the wheel hub flange.
    4. IMPORTANT: Make sure that the wheel stud is fully seated against the wheel hub flange.
  4. Remove the wheel nut and washers.
  5. Install the wheel hub/speed sensor assembly into the steering knuckle. Refer to Wheel Bearing/Hub Replacement - Front .
  6. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals