Installation Procedure

Fig 1: Battery Cable Harness & Retainers

Courtesy of GENERAL MOTORS CORP.

Fig 2: Positive Battery Cable & Starter Solenoid Wire At Starter Motor

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the positive battery cable nut (8) to the starter motor BAT terminal.
Tighten: Tighten the nut to 10 N.m (89 lb in).
Install the ground wire and the transaxle stud nut.
Tighten: Tighten the nut to 25 N.m (18 lb ft).
Install the front lower air deflector. Refer to Radiator Air Baffle and Deflector Replacement - Lower in Engine Cooling.
Lower the vehicle.

Fig 3: Positive Battery Cable At Underhood Accessory Wiring Junction Block

Courtesy of GENERAL MOTORS CORP.

Install the positive battery cable (2) to the underhood accessory wiring junction block.
Install the positive cable junction block lead nut (1).
Tighten: Tighten the nut to 10 N.m (89 lb in).

Fig 4: Remote Positive Stud Cover

Courtesy of GENERAL MOTORS CORP.

Fig 5: Disconnecting/Connecting Battery Cables

Courtesy of GENERAL MOTORS CORP.

Install the ground wire and the bolt to the frame.
Tighten: Tighten the bolt to 10 N.m (89 lb in).
Connect the positive battery cable.
Tighten: Tighten the terminal bolt to 15 N.m (11 ft lb).
Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .