Manual A/C Torque Specifications
MANUAL A/C TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) |
|---|---|
| A/C Compressor Bottom Bolt (3.4L) | 37 (50) |
| A/C Compressor Bracket Lower Bolt (3.8L) | 37 (50) |
| A/C Compressor Bracket Upper Bolt (3.8L) | 37 (50) |
| A/C Compressor Front Nuts (3.8L) | 74 (100) |
| A/C Compressor Hose-To-A/C Compressor Nut/Bolt | 24 (33) |
| A/C Compressor Hose-To-A/C Condenser Nut | 12 (16) |
| A/C Compressor Hose-To-Accumulator Nut | 12 (16) |
| Evaporator Core Block Fitting Bolt | 12 (16) |
| Liquid Line At Block Fitting Bolt | 12 (16) |
| Liquid Line Nut At Condenser | 20 (27) |
| Liquid Line Nut At Orifice | 20 (27) |
| Suction Hose At Block Fitting Bolt | 12 (16) |
| Suction Hose Nut At Accumulator | 35 (47) |
| INCH Lbs. (N.m) | |
| A/C Compressor Pressure Relief Valve | 80 (9) |
| A/C Refrigerant Pressure Sensor | 41 (4.7) |
| Accumulator Bracket Bolt | 36 (4) |
| Air Distributor Case Cover Screws | 13 (1.5) |
| Air Duct Bolts | 89 (10) |
| Air Duct Center Screw | 16 (1.8) |
| Air Inlet Housing Screws | 13 (1.5) |
| Air Temperature Actuator Screw | 13 (1.5) |
| Blower Motor Bolts | 12 (1.3) |
| Blower Motor Resistor Bolts | 13 (1.5) |
| Heater Core Cover Screws | 13 (1.5) |
| Heater Core Line Clamp Screw | 13 (1.5) |
| Heater Core Mounting Clip Screw | 13 (1.5) |
| Heater Core Outlet Cover Screws | 13 (1.5) |
| Heater Hose Support Bracket Nut (3.8L) | 40 (4.5) |
| Heater Inlet Pipe Adapter Bolt (3.8L) | 62 (7) |
| Heater Inlet Pipe Nut (3.4L) | 62 (7) |
| Heater Outlet Pipe Adapter Bolt (3.8L) | 62 (7) |
| HVAC Control Retaining Screw | 16 (1.8) |
| HVAC Module-To-Dash Bolts/Nuts | 89 (10) |
| HVAC Module Upper Case Screws | 13 (1.5) |
| Instrument Panel Compartment Screw | 18 (2) |
| Service Port Valve Core | 106 (12) |
| Vacuum Tank Screws | 13 (1.5) |