Spark Plug Replacement

REMOVAL PROCEDURE
1. Remove all foreign material from around the spark plug holes.
2. Remove the spark plug wires.




3. Remove the spark plugs using a spark plug socket.

INSTALLATION PROCEDURE
1. Using a round wire type spark plug gap gage, inspect the spark plug gap and adjust as necessary. Refer to Ignition System Specifications.

IMPORTANT: While gapping the spark plugs be sure to keep the platinum pads aligned to ensure maximum spark plug life.




2. Install the spark plugs using the spark plug socket.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the spark plugs to 18 N.m (13 lb ft).

3. Apply dielectric lubricant to the inside of the spark plug wire insulator boots.
4. Reinstall the spark plug wires.