LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> SSR Base >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Repair Instructions >> Seat Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying Front Seat Mount Nuts
    GM1150156Courtesy of GENERAL MOTORS CORP.
  1. Install the seat to the vehicle.
  2. Connect the electrical harness. Clip the harness to the seat bracket.
  3. Connect the yellow SIR electrical connector.
  4. Connect the seat belt buckle electrical connector.
  5. Install the front seat mounting bolt. Do not tighten.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Install the 3 front seat mounting nuts on the floor studs.

    Tighten: 

    • Tighten the front seat mounting nuts to 45 N.m (33 lb ft).
    • Tighten the front seat mounting bolt to 45 N.m (33 lb ft).

  7. Feed the seat belt through the seat guide loop and install the seat belt anchor bolt. Refer to Seat Belt Replacement - Front in Seat Belts.
  8. Enable the SIR. Refer to SIR Disabling and Enabling Zone 7 and to SIR Disabling and Enabling Zone 9 in SIR.
  9. Install the seat mounting fastener covers.
scientia non olet · About LEMON Manuals