LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2003 >> Venture Base, Van Cargo Extended >> Repair and Diagnosis >> External Pages >> Different car >> Section 201 (Front Suspension System) >> Repair Instructions >> Strut, Strut Component and/or Spring Replacement >> Disassemble Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Disassemble Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the strut from the vehicle. Refer to Strut Assembly Replacement .
  2. Install the strut to the following components:
    • J 34013-B
    • J 34013-971
    • J-34013-972
    Fig 1: Removing Strut & Components
    G01828343Courtesy of GENERAL MOTORS CORP.
  3. Rotate the 34013 J-B forcing screw (3) until the spring compresses slightly.
  4. Use the T 45 TORX® and the J 42991  in order to remove the strut shaft nut.
  5. Install the J 34013-197  to help guide the strut shaft out of the strut upper mount.
    NOTE: Care should be taken to avoid chipping or scratching the coating when handling the suspension coil spring. Damage to the coating can cause premature failure.
  6. Loosen the compressor forcing screw while guiding the strut shaft out of the strut upper mount. Continue loosening the compressor forcing screw until you can remove the strut and the spring.
    Fig 2: Rotating 34013 J-B Forcing Screw Until Spring Compresses
    G01828344Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals