Control Assembly: Service and Repair
HVAC CONTROL ASSEMBLY REPLACEMENTREMOVAL PROCEDURE
1. Remove the IP cluster trim plate.
2. Remove the retaining screw from the left edge of the HVAC control assembly.
3. Pivot the HVAC control assembly from the IP.
4. Remove the HVAC control assembly from the IP in order to access the vacuum and the electrical connectors.
5. Disconnect the following items from the HVAC control assembly:
- The electrical connectors
- The vacuum connectors
INSTALLATION PROCEDURE
1. Connect the following items to the HVAC control assembly:
- The vacuum connectors
- The electrical connectors
2. Align the tab on the HVAC control assembly with the slot in the IP.
3. Install the HVAC control assembly to the IP.
4. Install the screw to the HVAC control assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screw to 2 N.m (18 lb in).
5. Install the IP cluster trim plate.