Throttle Position Sensor: Service and Repair

THROTTLE POSITION (TP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Remove the engine cover.
2. Disconnect the throttle position (TP) sensor harness connector.




3. Remove the mounting bolts from the TP sensor.

NOTE: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent, as damage may result.




4. Remove the TP sensor and gasket from the throttle body assembly.

INSTALLATION PROCEDURE




1. With the throttle valve closed, install the TP sensor on the throttle shaft.
Rotate the TP sensor counterclockwise in order to align the mounting holes.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the TP sensor mounting bolts.

Tighten
Tighten the bolts to 2 Nm (18 lb in.).




3. Connect the TP sensor harness connector.
4. Install the engine cover.