Wiper Motor Module Replacement (Front)

WIPER MOTOR MODULE REPLACEMENT (FRONT)

REMOVAL PROCEDURE




1. Remove the wiper motor electrical connector.
2. Remove the cover screws.
3. Remove the cover.
4. Remove the circuit board and terminal module by lifting up on the terminal.

INSTALLATION PROCEDURE




1. Install the circuit board and terminal module.
2. Install the cover and 3 screws.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the screws to 2.6 N.m (23 lb in).

3. Install the wiper motor electrical connector.