Wiper Motor Module Replacement (Rear)

WIPER MOTOR MODULE REPLACEMENT (REAR)

REMOVAL PROCEDURE




1. Remove the liftgate garnish molding.
2. Disconnect the two electrical connectors from the controller module assembly.
3. Drill the heads from the rivets with an appropriate drill bit.
4. Remove two rivets and the controller assembly from the liftgate.

INSTALLATION PROCEDURE




1. Install the controller module assembly onto the liftgate.
2. Install two new rivets with a hand-held rivet gun.
3. Connect the two electrical connectors to the controller assembly.
4. Install the liftgate garnish molding.