Input 1
- Driver Door Jamb Sw.
-
The scan tool displays the position of the drivers door. The scan tool displays ACTIVE when the drivers door is open.
- Ignition 1
-
The BCM uses this data in order to determine the position of the ignition switch. The scan tool displays ACTIVE when the ignition switch is in the RUN or CRANK position.
- Ignition 3
-
The BCM uses this data in order to determine the position of the ignition switch. The scan tool displays ACTIVE when the ignition switch is in the RUN position only.
- Ignition Power Mode
-
The scan tool displays the position of the ignition switch. The scan tool displays OFF, RUN, CRANK and UNKNOWN. The scan tool displays UNKNOWN when the BCM can not determine the position of the ignition switch.
- Key in Ignition
-
The scan tool displays the position of the ignition key in the ignition switch cylinder. The scan tool displays YES when the ignition key is inserted into the ignition switch cylinder. The BCM uses this data in controlling the operation of the reminder chime feature.
- Pass. Door Jamb Sw.
-
The scan tool displays the position of the front passenger door. The scan tool displays ACTIVE when the front passenger door is open.
- RAP Relay Feedback
-
The scan tool displays the state of the RAP relay. The scan tool displays ON when the RAP relay is energized.
- Side Door Jamb Switch
-
The scan tool displays the position of the side door. The scan tool displays ACTIVE when the side door is open.