Installation Procedure
- Handle the MAF sensor carefully.
- Do not drop the MAF sensor in order to prevent damage to the MAF sensor.
- Do not damage the screen located on the air inlet end of the MAF.
- Do not touch the sensing elements.
- Do not allow solvents and lubricants to come in contact with the sensing elements.
- Use a small amount of a soap based solution in order to aid in the installation.
- Install the air cleaner outlet duct to the MAF sensor.
- Connect the IAT sensor harness connector.
- Install the air cleaner outlet duct (2) on the throttle body assembly.
- Tighten the retaining nut (1).
Tighten: Tighten the nut 2 N.m (18 lb in).
- Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.
- Connect the negative battery cable.
NOTE:
NOTE:
Refer to Fastener Notice in Cautions and Notices.