April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

Fig 1: Exploded View Ignition Control Module

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the ignition control module (2) and the heat sink (1) on the bracket with the screws (4).
Tighten: Tighten the screws to 3.5 N.m (31 lb in).
Reconnect the electrical connectors (3).
Install the engine cover. Refer to Engine Cover Replacement in Interior Trim.