LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala Base, 3.4 E >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System 3.8L (Introduction)) >> Repair Instructions >> Mass Air Flow (MAF) Sensor Replacement >> Removal Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement in Engine Mechanical - 3.8L.
    2. IMPORTANT: The mass air flow (MAF) sensor is attached to the throttle body assembly.
  2. Disconnect the MAF sensor electrical connector (8).
  3. Remove the MAF sensor screws (9).
  4. Remove the MAF sensor (1).
    5. Fig 1: Removing MAF Sensor
    GM378168Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals