Installation Procedure

WARNING: This page is about a different car, the 2007 Chevrolet Malibu. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying SIR Front End Sensor

Courtesy of GENERAL MOTORS CORP.

Install the front end sensor to the vehicle.

NOTE: Refer to Fastener Notice .

Install the 2 integral bolts that retain the front end sensor to the frame front crossmember.
Tighten: Tighten the bolts to 8 N.m (71 lb in).
Connect the sensor electrical connector to the front end sensor.
Install the CPA to the sensor electrical connector.
Install the air cleaner intake duct. Refer to Air Cleaner Inlet Duct Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling .