LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 587 (Front Suspension System) >> Repair Instructions >> Strut, Strut Component and/or Spring Replacement >> Assembly Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Assembly Procedure

WARNING: This page is about a different car, the 2007 Buick Lucerne. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Compressor Forcing Screw & Coil Spring
    GM743241Courtesy of GENERAL MOTORS CORP.
  1. Install the coil spring and upper strut mount to the J 45400  . See Special Tools .
  2. Turn the spring compressor forcing screw (1) until the coil spring is compressed.
  3. Install the strut to the coil spring and upper strut mount.
    4. Fig 2: Removing/Installing Strut Retaining Nut
    GM1079158Courtesy of GENERAL MOTORS CORP.
  4. Loosely install the strut retaining nut.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Use a 45 TORX® socket to hold the strut shaft. Use the J-35669  to install the upper strut mount nut. See Special Tools .

    Tighten:  Tighten the strut mount nut to 75 N.m (55 lb ft).

  6. Remove the strut from the J 45400  . See Special Tools .
  7. Install the strut to the vehicle. Refer to Strut Assembly Replacement .
scientia non olet · About LEMON Manuals