LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Malibu Base >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Bracket Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Installing Generator Bracket
    GM1239046Courtesy of GENERAL MOTORS CORP.
  1. Install the generator bracket.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the generator bracket bolts.

    Tighten:  Tighten the bolts in sequence to 50 N.m (37 lb ft).

    3. Fig 2: Installing Drive Belt Tensioner
    GM1239042Courtesy of GENERAL MOTORS CORP.
  3. Install the drive belt tensioner.
  4. Install the drive belt tensioner bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  5. Install the drive belt idler pulley.
  6. Install the drive belt idler pulley bolt.

    Tighten:  Tighten the bolt to 50 N.m (37 lb ft).

  7. Install the generator. Refer to Generator Replacement (L61)  or Generator Replacement (LX9) .
  8. Rotate the drive belt tensioner counterclockwise.
    9. Fig 3: Installing Drive Belt
    GM1239067Courtesy of GENERAL MOTORS CORP.
  9. Install the accessory drive belt. Refer to Drive Belt Replacement in Engine Mechanical - 3.5L (LX9).
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure .
scientia non olet · About LEMON Manuals