Removal Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2004 GMC Yukon XL, 2004 GMC Yukon, 2004 Chevrolet Tahoe, 2004 Chevrolet Suburban, and 2004 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Support the lower control arm with a safety stand.
- Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the stabilizer shaft links from the lower control arm. Refer to Stabilizer Shaft Replacement .
- Remove the shock absorber lower nut and the bolt. Refer to Shock Absorber Replacement .
- Remove the torsion bars. Refer to Torsion Bar Replacement .
- Remove the wheel drive shaft. Refer to Wheel Drive Shaft Replacement in Wheel Drive Shafts.
- Remove the lower ball joint retaining nut.
- Disconnect the lower ball joint stud from the steering knuckle using J 43631 and J 45851 . See Special Tools and Equipment .
- Remove the lower control arm nuts and the 15-series washers.
- Remove the lower control arm bolts.
- Remove the lower control arm nuts and the 25/35-series washers.
- Remove the lower control arm bolts.
- Remove the lower control arm.