LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> External Pages >> Different car >> Section 686 (Engine Control System - 5.3L - Introduction) >> Repair Instructions >> Powertrain Control Module (PCM) Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install electrical connections to PCM.

    Tighten:  Tighten bolts to 10 N.m (89 lb in).

  2. Install the PCM to the bracket.
  3. Position PCM water boot back into place.
  4. Close the hood.
  5. Connect negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Engine Electrical.
  6. If the PCM was replaced, the replacement PCM must be programmed. Refer to Service Programming System (SPS) (Remote Procedure) or Service Programming System (SPS) (Pass-Thru Procedure) or Service Programming System (SPS) (Off Board Remote Procedure) or Service Programming System (SPS) (Off Board Pass-Thru Procedure) in Programming.
scientia non olet · About LEMON Manuals