Scan Tool Data Definitions

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.

The SIR scan tool data definitions contain a brief description of all SIR related parameters available on the scan tool. The parameters that are available on the scan tool are listed below in alphabetical order.

8-Digit GM Part Number: The scan tool displays an 8-digit part number. This number is the GM part number that is stored within the SDM memory.
Active Switch: The scan tool displays enabled or disabled. The signal from the inflatable restraint I/P module disable switch indicates whether the passenger frontal air bag is enabled or disabled.
Calibration ID: The scan tool displays a 4-digit number. This calibration ID is the check sum of the SDM read only memory contents.
Component Serial Number: The scan tool displays the SDM serial number.
Driver Side Belt Status: The scan tool displays Buckled or Unbuckled. The signal from the driver seat belt switch indicates whether the driver seat is buckled or unbuckled.
Driver Side Impact Sensor ID: The scan tool displays a 2-digit ID number. The ID signal is sent to the SDM from the Driver SIS.
Electronic Front End Sensor 1 ID: The scan tool displays a 2-digit ID number. The ID signal is sent to the SDM from the left hand front end sensor.
Electronic Front End Sensor 2 ID: The scan tool displays a 2-digit ID number. The ID signal is sent to the SDM from the right hand front end sensor.
Ignition Voltage: The scan tool displays 0-20 volts. The ignition represents the system voltage measured by the SDM at its ignition feed.
Julian Date of Build: The scan tool displays a 3-digit number. Which represents the day of the year the module was built.
Passenger Side Impact Sensor ID: The scan tool displays a 2-digit ID number. The ID signal is sent to the SDM from the Passenger SIS.
ROM ID: The scan tool displays a 4-digit number. This number is the read-only memory (ROM) ID.
Year Module Built: The scan tool displays what year the module was built.