Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing PSIR Inflator Module

Courtesy of GENERAL MOTORS CORP.

Install the PSIR inflator module to the front of the I/P carrier.

Fig 2: Identifying Lower PSIR Inflator Module Retaining Bolts

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Install the 2 lower PSIR inflator module retaining bolts (1).
Tighten: Tighten the nuts until fully driven, seated, and not stripped.
Connect electrical connection to the PSIR inflator module.
Connect the PSIR CPA.

Fig 3: Identifying Upper Passenger Supplemental Inflatable Restraint Fasteners

Courtesy of GENERAL MOTORS CORP.

Using a 1/4 drive ratchet, an 8-inch extension with a universal adapter, and a 10 mm deep well socket, install the 2 upper passenger supplemental inflatable restraint (PSIR) nuts (1).
Tighten: Tighten the nuts until fully driven, seated and not stripped.
Install the right side knee bolster. Refer to Knee Bolster Replacement - Right in Instrument Panel, Gages, and Console.
Install the left side knee bolster. Refer to Knee Bolster Replacement - Left in Instrument Panel, Gages, and Console.
Install the I/P compartment door to the vehicle. Refer to Storage Compartment Replacement - Instrument Panel (I/P) in Instrument Panel, Gages, and Console.
Install the passenger seat. Refer to Seat Replacement in Seats.
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5 .