LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> External Pages >> Different car >> Section 696 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove any dirt, grease, etc. from the mounting surface.
  2. Install the SDM to the vehicle.
  3. Connect the electrical connection to the SDM.
    4. Fig 1: View of SDM Electrical Connector Locking Arm
    GM1343515Courtesy of GENERAL MOTORS CORP.
  4. Rotate the locking arm (1) to lock the electrical connector to the SDM.
    5. Fig 2: Identifying Connection Position Assurance
    GM1343513Courtesy of GENERAL MOTORS CORP.
  5. Install the CPA (1) to the SDM.
    6. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  6. Install the nuts that retain the SDM to the floor panel.

    Tighten:  Tighten the nuts to 12 N.m (106 lb in).

  7. Install the floor console. Refer to Console Replacement in Instrument Panel, Gages and Console.
    8. IMPORTANT: The AIR BAG indicator may remain ON after the SDM has been replaced. DTC B1001 may set requiring that the SDM part number to be setup in multiple modules. If the indicator remains ON after enabling the SIR system, perform the diagnostic system check and follow steps thoroughly to ensure that the SDM is setup properly.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 8 .
scientia non olet · About LEMON Manuals