LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> SSR >> Repair and Diagnosis >> External Pages >> Different car >> Section 696 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - Front >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2003 Chevrolet SSR. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Inflatable Side Impact Module to Seat Back Frame Screws
    GM1200424Courtesy of GENERAL MOTORS CORP.
  1. Install the SIR wiring harness to the seat.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the inflatable side impact module to the seat back frame with the 2 screws.

    Tighten:  Tighten the inflatable side impact module screws to 6 N.m (55 lb in).

  3. Install the front seat back panel. Refer to Seat Back Panel Replacement - Front in Seats.
  4. Install the seat back cover and pad. Refer to Seat Back Cover and Pad Replacement - Front in Seats.
  5. Install the seat assembly to the vehicle. Refer to Seat Replacement in Seats.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 2  and SIR Disabling and Enabling Zone 6 .
scientia non olet · About LEMON Manuals