LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Tracker RWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Repair Instructions >> Cruise Control Cable Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

  1. Install the cruise control servo cable to the vehicle. Secure the cable with the retainer (2) and the grommet (4).
  2. Install the cruise control servo cable to the accelerator pedal (1).
    3. Fig 1: View Of Cruise Control Servo Cable To Accelerator Pedal
    GM488525Courtesy of GENERAL MOTORS CORP.
  3. Install the cruise control servo cable (3) to the cruise control servo cable retainers (5).
    4. Fig 2: View Of Cruise Control Servo Cable And Retainers
    GM488527Courtesy of GENERAL MOTORS CORP.
  4. Install the cruise control servo cable (3) to the cruise control servo assembly (1).
  5. Adjust the cruise control servo cable locknut (5) in order to adjust the cruise control cable play.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Adjust the cruise control servo cable play to 1-2 mm (0.04-0.08 in) at the servo closed throttle position.

    Tighten:  Tighten the cruise control servo cable locknut to 5 N.m (44 lb in).

    7. Fig 3: View Of Cruise Control Servo Cable To Servo Assembly
    GM488533Courtesy of GENERAL MOTORS CORP.
  7. Install the cruise control module cover (1).
    8. Fig 4: View Of Cruise Control Module Cover
    GM488523Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals