LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2004 >> Tracker RWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Repair Instructions >> Cruise Control Servo Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the cruise control servo assembly (6) to the vehicle. Secure the assembly with the 3 bolts (2).

    Tighten:  Tighten the cruise control servo assembly mounting bolts to 10 N.m (89 lb ft).

  2. Connect the cruise control servo assembly electrical connector.
    3. Fig 1: View Of Cruise Control Servo Cable To Retainers
    GM488527Courtesy of GENERAL MOTORS CORP.
  3. Install the cruise control servo cable (3) to the cruise control actuator lever (1).
  4. Adjust the cruise control servo cable locknuts (5) in order to adjust the cruise control servo cable play.
  5. Adjust the cruise control servo cable play to 1-2 mm (0.04-0.08 in) at the servo closed throttle position.

    Tighten:  Tighten the cruise control cable locknut (5) to 5 N.m (44 lb in).

    6. Fig 2: View Of Cruise Control Servo Cable To Servo Assembly
    GM488533Courtesy of GENERAL MOTORS CORP.
  6. Install the cruise control module cover (1).
    7. Fig 3: View Of Cruise Control Module Cover
    GM488523Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals