Installation Procedure

IMPORTANT: Do not reuse the old mounting screws (1). Always install new mounting screws with the new EBCM.

Fig 1: Expanded View Of EBCM & BPMV

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the new screws (1) in the EBCM (2).
Tighten: Tighten the screws to 5 N.m (39 lb in) in an X-pattern.

Fig 2: View Of Fuel Pipe Shield Mounting Nuts

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connectors to the EBCM.
Secure the module (1) to the frame bracket (3) and fuel pipe shield (2) with the 2 nuts (4).
Revise the tire calibration using the Scan Tool Tire Size Calibration function.
Return to Diagnostic Starting Point - Antilock Brake System .