Removal Procedure

WARNING: This page is about a different car, the 2005 GMC Sierra, 2005 GMC Cab & Chassis Sierra, 2005 Chevrolet Silverado, and 2005 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: After installation, calibrate the new EBCM to the tire size that is appropriate to the vehicle.

CAUTION: Refer to BATTERY DISCONNECT CAUTION in Cautions and Notices.

Disconnect the negative battery cable.
Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

Fig 1: Identifying Chassis Electrical Connectors To EBCM

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The area around the EHCU MUST be free from loose dirt to prevent contamination of disassembled ABS components.

Thoroughly wash all contaminants from around the EHCU.
Disconnect the chassis electrical connectors from the EBCM.

Fig 2: Removing EBCM To BPMV Mounting Screws

Courtesy of GENERAL MOTORS CORP.

Remove the mounting screws (1) that fasten the EBCM (2) to the BPMV (3).

Fig 3: Removing EBCM From BPMV

Courtesy of GENERAL MOTORS CORP.

NOTE: Do not use a tool to pry the EBCM or the BPMV. Excessive force will damage the EBCM.

Remove the EBCM (2) from the BPMV (3). Removal may require a light amount of force.

Fig 4: Disc

Courtesy of GENERAL MOTORS CORP.

Disconnect the BPMV electrical connector from the EBCM.
Clean the BPMV to EBCM mounting surfaces with a clean cloth.