LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Chevy Express H1500, Van Cargo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System - 6.0L (CNG) - Introduction) >> Repair Instructions >> Fuel Injection Control Module Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  1. Disconnect the negative battery cable. Refer to BATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDURE in Engine Electrical.
    2. Fig 1: FICM Components
    GM893898Courtesy of GENERAL MOTORS CORP.
  2. Remove the fender brace mounting bolts (3).
  3. Remove the fender brace.
  4. Remove the FICM hold-down screws (7) from the mounting bracket.
  5. Remove the connector position assurance lock and disconnect the electrical connector (2) from the FICM.
  6. Remove the FICM.

    If the FICM mounting bracket does not have to be removed proceed to Step 3 of the Installation Procedure.

  7. Remove the FICM mounting bracket bolts (1).
  8. Remove the FICM mounting bracket nut (4) from the horn mounting stud.
  9. Remove the FICM mounting bracket from the vehicle.
scientia non olet · About LEMON Manuals