Installation Procedure
WARNING: This page is about a different car, the 2007 Pontiac G5 Pursuit, 2007 Pontiac G5, and 2007 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wiper washer switch from the SIR coil module assembly. Refer to Wipers/Washer Switch Replacement .
- Install the headlamp/turn signal switch to the SIR coil module assembly. Refer to Turn Signal Multifunction Switch Replacement .
- Install the headlamp/turn signal switch screws.
- Verify the SIR coil is in the center position. Refer to Inflatable Restraint Steering Wheel Module Coil Centering .
- Slide the SIR coil assembly on the steering column and snap into place.
- Connect the wiper/washer harness connector to the SIR coil module assembly.
- Connect the headlamp/turn signal harness connector to the SIR coil module assembly.
- Connect the SIR coil harness connector to the SIR coil module assembly.
- Install the steering column covers. Refer to Steering Column Trim Covers Replacement .
- Install the steering wheel. Refer to Steering Wheel Replacement .
- Install the inflatable restraint steering wheel module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
- Enable the SIR system. Refer to SIR Disabling and Enabling .