LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Impala Base, 3.4 E >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - 3.4L - Introduction (2 Of 2) >> Repair Instructions >> Accelerator Controls Cable Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

    Fig 1: Removing/Installing Accelerator Cable & Components
    GM12287Courtesy of GENERAL MOTORS CORP.
  1. Remove the left instrument panel sound insulator. Refer to Closeout/Insulator Panel Replacement - Left in Instrument Panel, Gages, and Console.
  2. Remove the accelerator cable (5) from the accelerator pedal (1).
  3. Install a piece of mechanics wire to the accelerator cable to aid in the installation of the new cable.
    4. Fig 2: View Of Accelerator Cable Through Bulkhead
    GM12262Courtesy of GENERAL MOTORS CORP.
  4. Squeeze the accelerator cable cover tangs and push the accelerator cable through the cowl.
    5. Fig 3: Identifying Throttle Cable Bracket With Cables
    GM12735Courtesy of GENERAL MOTORS CORP.
  5. Remove the accelerator cable shield, if equipped.
  6. Remove the accelerator cable from the retaining clip.
  7. Remove the cruise control cable from the throttle body lever.
  8. Remove the cruise control cable from the accelerator cable bracket.
  9. Remove the accelerator cable from the throttle body lever.
  10. Remove the accelerator cable from the accelerator cable bracket.
    11. IMPORTANT: Note the routing of the accelerator controls cable for removal.
    Fig 4: Identifying Accelerator Cables
    GM12734Courtesy of GENERAL MOTORS CORP.
  11. Remove the mechanics wire from the cable and remove the cable.
scientia non olet · About LEMON Manuals