LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> Impala LS >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Module Replacement - Front >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Monte Carlo and 2004 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 7 .
    2. CAUTION: Following the deployment of a side impact air bag, replace the following parts:
    • The seat back trim
    • The seat back pad
    • The seat back frame

    Failure to do so may cause future personal injury.
  2. If the air bag has been deployed, replace the seat back trim, the seat back pad, and the seat back frame Refer to Seat Back Frame Replacement - Front in Seats.
  3. Remove the seat back cover, as needed. The head restraint does not need to be removed. Refer to Seat Back Cover Replacement - Front in Seats.
  4. Remove the driver side air bag fasteners (2).
  5. Note the routing of the air bag wiring harness (4) and the retaining clip attachments within the driver seat.
  6. Remove the wiring harness (4) retaining clips from the driver seat frame.
  7. Gently pull the pigtail harness up into the seat cushion and the seat back, while guiding the harness through the wire triangle of the seat frame.
  8. Remove the module (1) from the driver seat back frame.
  9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping .
    10. Fig 1: Inflatable Restraint Side Impact Module & Components - Front
    GM307452Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals