Removal Procedure

WARNING: This page is about a different car, the 2006 Pontiac Montana SV6, 2006 Chevrolet Uplander, and 2006 Buick Terraza. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front floor console reinforcement. Refer to Bracket, Reinforcement, Side Trim Panel Replacement - Front Floor Console in Instrument Panel, Gages and Console.

Fig 1: Identifying Electronic Brake Control Module

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector (3) from the yaw rate sensor.
Remove the nuts (2) retaining the yaw rate sensor.
Remove the yaw rate sensor (1) from the console bracket.