Installation Procedure

Fig 1: Removing & Installing Shift Knob And Shift Control Shaft Trim

Courtesy of GENERAL MOTORS CORP.

Install the new shift knob wiring through the shift control shaft trim and reinstall the shift knob and trim as an assembly.
Install the shift knob wiring harness in the retaining tabs on the shift control assembly.
Connect the shift knob electrical connector.

Fig 2: Removing & Installing Shift Knob Setscrew

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the shift knob on the shift control shaft and reinstall the setscrew.
Tighten: Tighten the shift knob setscrew to 2 N.m (17 lb in).
Install the shift control shaft trim by pushing up until it snaps onto the lower portion of the shift knob.
Install the center console. Refer to (Center Console Replacement) in Interior Trim.