LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 136 (Cruise Control System) >> Repair Instructions >> Cruise Release Switch Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: The notch on the plunger will be fully visible when the plunger is all the way out.
    Fig 1: Removing & Installing Cruise Brake Switch
    GM893285Courtesy of GENERAL MOTORS CORP.
  1. Pull the switch plunger all the way out to prepare for adjustment. It may require the use of moderate force.
  2. Connect the cruise brake switch harness connector. Push the connector in until a click is heard and pull back to confirm a positive engagement.
  3. Install the cruise brake switch into the bracket and rotate 180 degrees while holding the brake pedal down during installation.
  4. Adjust the cruise brake switch by pulling the brake pedal all the way up by hand. The switch internal ratchet mechanism will lock the switch in the adjusted position.
  5. Install the left side lower heater duct and push pin fastener.
  6. Install the left side lower I/P closeout panel (hush panel) and push pin fasteners.
scientia non olet · About LEMON Manuals