LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 142 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Steering Wheel Module Coil Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Saturn L300. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Inflatable Restraint Steering Wheel Module Roll Connector
    GM890633Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: A new roll connector is equipped with a yellow tab that is removed after the steering wheel is installed. This tab passes through the steering wheel.
  1. Route the SIR wiring harness and horn/cruise connector behind the turn signal lever combination switch and down the steering column.
  2. Install the roll connector to the turn signal lever combination switch housing.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the upper and lower steering column trim covers. Refer to Steering Column Trim Covers Replacement .
  4. Install the steering wheel. Refer to Steering Wheel Replacement in Steering Wheel and Column.
  5. Install the driver inflator module. Be sure to seat all the attachment points. Refer to Inflatable Restraint Steering Wheel Module Replacement  in Steering Wheel and Column.
  6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 .
scientia non olet · About LEMON Manuals