Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Install a stationary window into the opening. Refer to Urethane Adhesive Installation of Stationary Windows .

Fig 1: Applique To Windshield Frame

Courtesy of GENERAL MOTORS CORP.

Install the windshield side reveal moldings. Refer to Side Reveal Molding Replacement (Coupe and Convertible) or Side Reveal Molding Replacement (Hardtop) .

Fig 2: Windshield Weather-Strip

Courtesy of GENERAL MOTORS CORP.

Install the windshield weatherstrip. Refer to Weatherstrip Replacement (Coupe and Convertible) or Weatherstrip Replacement (Hardtop) .

Fig 3: Rearmost Screws At Top Of Fender To Wheelhouse

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the fender mounting screws.
Tighten: Tighten the screws to 1.9 N.m (17 lb in).

Fig 4: Air Inlet Grille Panel

Courtesy of GENERAL MOTORS CORP.

Install the air inlet screen. Refer to Air Inlet Grille Panel Replacement .

Fig 5: Plenum To Hood Seal

Courtesy of GENERAL MOTORS CORP.

Install the air inlet screen seal. Refer to Air Inlet Grille Panel Replacement .
Install the windshield wiper arms and washer hoses. Refer to Wiper Arm, Blade, Insert Replacement - Front .

Fig 6: Windshield Side Garnish Moldings & Retainer Clips To Windshield Frame

Courtesy of GENERAL MOTORS CORP.

Install the windshield side garnish moldings.

Fig 7: View Of Inside Rearview Mirror

Courtesy of GENERAL MOTORS CORP.

Remove the rearview mirror. Refer to Rearview Mirror Replacement (Except DD8) or Rearview Mirror Replacement (DD8) .
Perform the appropriate step:
- For the coupe, install the roof lift-off panel.
- For the convertible, raise and close the folding top.
Close the door windows.
Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
Close the hood.