Remote Control Door Lock Receiver

If the remote control door lock receiver (RCDLR) is replaced, the following procedures must be performed in the order listed below:

1. Perform the Keyless Entry Transmitter Programming procedure. Refer to Transmitter Programming (Domestic and Japan) or Transmitter Programming (Export - Including Canada) in Keyless Entry. Use Method 1 to perform the programming.
IMPORTANT: The Theft Deterrent 10-Minute Relearn Procedure for the SCLM must be done first. Failure to do so may result in complications when attempting to perform the Theft Deterrent 10-Minute Relearn Procedure for the ECM.
2. Perform the Theft Deterrent 10-Minute Relearn Procedure for the Steering Column Lock Module (SCLM) - Refer to Programming Theft Deterrent System Components (Domestic, Canada, and Japan) or Programming Theft Deterrent System Components (Export ) in Theft Deterrent, selecting the Programming Theft Deterrent System Components that matches your vehicles country of origin.

   During the SCLM programming, select Theft Deterrent Learn for Column Lock Module (Export Only) on the SPS terminal.

3. Perform the Theft Deterrent 10-Minute Relearn Procedure for the Engine Control Module (ECM) - Refer to Programming Theft Deterrent System Components (Domestic, Canada, and Japan) or Programming Theft Deterrent System Components (Export ) in Theft Deterrent, selecting the Programming Theft Deterrent System Components that matches your vehicles country of origin.

   During the ECM programming, select Theft Deterrent Learn for ECM (Export Only) on the SPS terminal.

4. Perform the procedure to set up a new remote control door lock receiver.
   1. Connect the Tech 2 to the vehicle.
   2. Select RCDLR under Module Setup in the Vehicle Control Systems menu.
   3. Select Setup New RCDLR.
   4. Follow the on-screen instructions.
5. Perform the tire pressure sensor learn procedure. Refer to Tire Pressure Sensor Learn in Tire Pressure Monitoring.