LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls (Introduction)) >> Repair Instructions >> Accelerator Pedal with Position Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.
    Fig 1: Accelerator Pedal Sensor Module Electrical Connector
    GM43534Courtesy of GENERAL MOTORS CORP.
  1. Remove the left instrument panel (I/P) on the lower closeout insulator panel. Refer to Closeout/Insulator Panel Replacement - Instrument Panel (I/P) Lower in Instrument Panel, Gages and Console.
  2. Disconnect the electrical connector of the accelerator pedal sensor module.
    3. Fig 2: Accelerator Pedal Mounting & Bolts
    GM43535Courtesy of GENERAL MOTORS CORP.
  3. Remove the accelerator pedal mounting bolts.
  4. Remove the accelerator pedal.
scientia non olet · About LEMON Manuals