LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2005 >> SSR Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 212 (Engine Controls (Introduction)) >> Repair Instructions >> Fuel Injector Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2005 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: If the fuel injectors are being removed for the replacement of the fuel rail, it is not necessary to replace the O-rings on the fuel injector. Replace the O-rings only if they are damage.
    Fig 1: Fuel Rail Assembly
    GM1467502Courtesy of GENERAL MOTORS CORP.
  1. Apply a small amount of clean motor oil to the O-rings (8) and (9), before installing the new fuel injector.
  2. Install the fuel injector (7) in the fuel rail (2).
  3. Install the retaining clips for the fuel injector (6).
  4. Reconnect the electrical connector (50 for the fuel injector (7).
  5. Install the fuel rail assembly (2). Refer to Fuel Rail Assembly Replacement .
  6. Inspect for leaks:
    1. Turn the ignition switch ON for 2 seconds.
    2. Turn the ignition switch OFF for 10 seconds.
    3. Turn the ignition switch ON.
    4. Inspect for fuel leaks.
scientia non olet · About LEMON Manuals